Skip to content

Setup Assembly Instructions

Setup Assembly Instructions

After you have viewed the set-up video, please review these additional notes about assembling your Body Action System: 

    • Do not overfill Weight Bags. No more than 25 lbs. per bag. Bags should easily bend over the legs so both ends are resting on the floor.

    • Do not force the upper part of the center bar on the main stand too far. Extend carefully and stop when you feel resistance. Please contact us immediately if the 2 vertical posts become separated as you will need a new part to stabilize the stand.

    • Do not over-tighten the clamps. Tighten only until snug and flip the lever to finish the process. Loosen the bolt if the lever seems too tight.

    • Torso Pad bolt connection is different from the other clamps. It actually uses the metal post that runs the length of the clamp as the nut instead of a butterfly nut. We do this so it acts like a hinge and the clamp can swing out of the way when you want to remove the pad. Please see the picture below if you are having any problem.

    • Be sure legs and weight bags are in back, behind the stand. The area in front of the BAS should be completely clear.

        Contact us at support@bodyactionsystem.com with any other questions. 

        Torso Clamp Assembly